For this model, the correct firmware file (a .bin image) is often specific to a particular LCD panel. You can find firmware files and discussions on electronics and repair forums like and VinaFix .
The board auto-negotiates pixel boundaries with mainstream operating systems. If elements appear stretched, enter your computer OS display preferences and select exactly at a 60Hz update rate. xyw58cdt9av7 manual full
To avoid severe personal injury, electric shock, or equipment degradation, strictly observe the following parameters during physical deployment. For this model, the correct firmware file (a
Reseat the 30-pin LVDS interface ribbon cable. Confirm your display panel supports a 1920x1080 resolution at 60Hz. Over-driven speaker load or impedance mismatch. If elements appear stretched, enter your computer OS
Generally 12V DC input (check your specific model for current requirements).
Additionally, the board includes a number of jumper headers and connectors: at minimum, you’ll find the LVDS output (often a 30‑pin or 40‑pin connector), a DC power jack, an HDMI port, a VGA port, an IR receiver header, and sometimes a jumper block for setting the panel’s backlight voltage (3.3V, 5V, or 12V). The board may also feature a few general‑purpose buttons (e.g., Menu, Input, Power, Volume Up/Down) that allow you to navigate the on‑screen display without a remote.
| Feature | Specification | | :--- | :--- | | | XY-W58CDT9-AV7, JRY-L58CDT9-GV2, JRY-W58CDT9-AV6, BV2, AV6 | | Main Control Chip | TSUMU58CDT9-1 (MStar) | | Input Interfaces | 1x HDMI, 1x VGA (D-Sub), 1x Audio In (3.5mm) | | Output Interface | Single/Dual Channel LVDS (typically 40-pin or 30-pin) | | Supported Resolutions | Up to 1920x1080 (Full HD) | | Power Input | DC 12V (Typical, check your specific board's silkscreen) | | Audio Output | 3.5mm headphone jack, supports 2x2W (4Ω) or 2x1.6W (8Ω) | | Physical Dimensions | Approximately 120mm x 60mm x 13mm (4.7" x 2.4" x 0.5") | | Control Interface | Pins for an external button board (Power, Menu, +, -, etc.) | | Backlight Connector | Marked "LED+" and "LED-" for connecting panel backlight |
Back to top