Connect the charger (if charging) or the load (if discharging) here.
Troubleshooting quick reference
Allows for manual activation of the relay for testing purposes. xycd60 manual
), and status symbols like "IN" (charging) or "OUT" (discharging).
Charging Control (P-1) and Discharging Control (P-2). Connect the charger (if charging) or the load
The XY-CD60 is an essential tool for "smart" power systems. By automating the transition between charging and discharging states, it reduces manual oversight and prevents the most common causes of battery failure. or provide a wiring diagram for a specific solar application?
The control board features a backlit LCD display and four tactile buttons. Charging Control (P-1) and Discharging Control (P-2)
if you tell me the type of battery (Li-ion, LifePO4, Lead-acid) and the voltage ( 12V12 cap V 24V24 cap V 48V48 cap V ) you are using.
For the most detailed, up‑to‑date information, refer to the manufacturer’s documentation.
| Code | Function | Description | Range/Default | | :--- | :--- | :--- | :--- | | | Heating / Cooling Mode | Sets the relay to activate on temperature drop (Heating) or rise (Cooling). | H (Heating) / C (Cooling) | | P1 | Hysteresis (Dead Band) | The difference between stopping and starting. If set to 2.0°C, the relay activates at Set Temp - 2°C (Heating mode). | 0.1°C – 15.0°C | | P2 | Delay Protection | Prevents rapid cycling of compressor/relay. (e.g., wait 3 minutes before restarting). | 0 – 10 Minutes | | P3 | High Alarm | Audible alarm triggers if temp exceeds this limit. | Off / Temp Value | | P4 | Low Alarm | Audible alarm triggers if temp drops below this limit. | Off / Temp Value | | P5 | Calibration | Corrects sensor reading errors. If actual temp is 25°C and display shows 24°C, set P5 to +1.0. | -5.0°C to +5.0°C |
The XY-CD60 features a clean LCD layout and three simple navigation buttons: UP , DOWN , and SET .