during certain boot stages or if there is a specific interface fault. Telstra.com Basic Installation Steps Connect Voice Equipment : Plug analogue phones or faxes into the
Ensure the operating environment stays between 0°C and 45°C (32°F to 113°F).
Blinks green during initialization. Solid green indicates the router firmware has loaded successfully and is operational. Red indicates a hardware or system failure.
: Connect the appropriate WAN cable (ADSL or Ethernet) to the designated Initial Configuration oneaccess one100 installation manual oneaccess top
Connect your service provider's line (DSL line to the DSL port, or fiber media converter to the Ethernet WAN port).
Before starting the installation, verify that your package contains all necessary components. Box Contents OneAccess ONE100 router unit AC power adapter and cable RJ-45 to DB-9 console cable Rack-mounting brackets with screws Quick start documentation Front and Rear Panel Interfaces
have a physical power switch and will boot automatically when plugged in. configuration command for the OneOS CLI? during certain boot stages or if there is
: Configure the voice routing table to map phone numbers to SIP accounts for call forwarding between ISDN/FXS ports and the SIP trunk. Save Settings
Secure the brackets tightly using the provided mounting screws.
Typically 4 x 10/100Base-TX Fast Ethernet ports for local network distribution. Solid green indicates the router firmware has loaded
Connect the provided RJ-45-to-DB-9 serial console cable to the console port of the router. Plug the DB-9 end into the serial port of your administration PC (or use a compatible USB-to-Serial converter). Step 4: Powering On and Initial Boot Sequence
Align the rack-mount brackets with the screw holes on the sides of the ONE100 chassis.