Mt6580 Imei Repair Code

Open the default stock phone dialer application and enter the primary MediaTek engineering code: *#*#3646633#*#*

AT +EGMR=1,10,"YOUR_15_DIGIT_IMEI"

Select (for the first SIM) and enter the command: AT+EGMR=1,7,"YOUR_NEW_15_DIGIT_IMEI" . mt6580 imei repair code

If your MT6580 device is rooted (Magisk or SuperSU), you do not need secret dialer codes.

*#*#3646633#*#* – Opens . From there: Connectivity → CDS Information → Radio Information → Phone 1 (or 2) . Commands to write IMEI: AT+EGMR=1,7,"IMEI_1" AT+EGMR=1,10,"IMEI_2" Limitation: Often requires root access on Android 6+ / MT6580. Without root, the command may be rejected. Open the default stock phone dialer application and

Connect the turned-off phone to the PC via the USB cable (Do not press any buttons unless your specific model requires holding Volume Down).

A: Some custom ROMs (LineageOS, Resurrection Remix) remove Engineer Mode. You must flash back to stock ROM. From there: Connectivity → CDS Information → Radio

*#*#3646633#*#* (If not working, try *#*#54298#*#* or *#*#225#*#* )

Type your 15-digit codes into the boxes and click . Troubleshooting Common Errors "Command Not Allowed in UserBuild"

A: You likely lost your NVRAM calibration data (RF parameters). Run the CDS information reset in Engineer Mode, or reflash the original modem firmware.

If your phone is properly rooted, this command writes the IMEI directly to the NVRAM. But here is the catch—on newer MT6580 security patches (mid-2016 onward), Google blocked this AT command via the modem_control service. You may get a ERROR or FAIL response.