Are you running into a during the setup?
The is a utility provided by Makerbase (MKS) for configuring laser engraving motherboards, such as the DLC32 . It is primarily used for flashing firmware, adjusting WiFi settings, and customizing the user interface on compatible laser machines. Download and Official Sources
Change Baud rate to 115200; close LightBurn/LaserGRBL before flashing. 5GHz Network or weak signal.
Inside the MKS-DLC32 repository, navigate to the Tools or Software folder. mks laser tool setup v112exe download link
Ensure your laser control software (LightBurn, LaserGRBL, or Cura) is completely closed. Only one program can occupy a COM port at a time.
: The installer often defaults to Chinese. Users typically need to click through the installation by selecting the middle or confirmation options to finish the setup. Driver Requirements : Ensure the CH340 USB-SERIAL driver
: Simplifies saving and transferring G-Code files to a TF card for offline engraving. 4. Troubleshooting Common Issues Are you running into a during the setup
Once completed, power-cycle your laser machine to boot into the new firmware. Configuring WiFi with MKS Laser Tool
Ensure the board is powered on independently if your computer’s USB port doesn't provide enough current. Unplug the cable, restart the MKS Laser Tool, and plug it back in.
Makerbase hosts all of their official tools, software, and firmware open-source on GitHub. Avoid downloading the installer from random file-sharing blogs, forums, or untrusted YouTube video descriptions. 2. Locate the Official Makerbase GitHub To find the legitimate, virus-free installer: Navigate to . Download and Official Sources Change Baud rate to
Click or Upload and wait for the progress bar to reach 100%. Do not disconnect the cable during this process. Configuring Wi-Fi Connections
: Follow the on-screen prompts, choose your installation path, and click Finish . 🔌 Installing Required Drivers (CH340)
