Available in Single-phase 230V AC (1.9kVA) or Three-phase 3x400V AC (+N) configurations running at 50–60 Hz.
+-------------------------------------------------------------+ | MAIN TERMINAL STRIP | +----+----+----+----+----+----+----+----+----+----+----+----+ | 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 | 11 | 12 | +----+----+----+----+----+----+----+----+----+----+----+----+ | L1 | N | PE |DI1 |DI2 |DI3 |DI4 |DIC |AI1 |AI2 |AIC |AO1 | +----+----+----+----+----+----+----+----+----+----+----+----+ TERMINAL DESCRIPTION: 1-2: AC Power Input (L1, Neutral) 3: Protective Earth (PE) 4-7: Digital Inputs 1 to 4 8: Digital Input Common (DIC) 9-10: Analog Inputs 1 and 2 11: Analog Input Common (AIC) 12: Analog Output 1
SHIFT + HOLD = warm boot (resets Z80 only, leaves 6809 state intact). dynalogic 4 manual full
The control box is a highly advanced, intelligent controller designed specifically for Dynaco high-speed roll-up doors . To ensure peak operational efficiency, maximum safety, and an extended lifespan for your industrial doors, understanding the complete technical parameters, wiring, and programming options is critical.
Available in Single-phase 230 V AC (1.9kVA) or Three-phase versions. Interface: Available in Single-phase 230V AC (1
Check the optical lenses on both sides of the door for dirt, dust, or physical blockage.
Instructions for upgrading the controller firmware for new features. To ensure peak operational efficiency, maximum safety, and
Navigates down through menu options or decrements numerical parameter values.
Verify positive (+) and negative (-) data lines are not reversed. Check termination resistor placement. Diagnostic Mode Testing
Read-only access to values; can acknowledge non-critical alarms. No password required.
