Cem Dual Mig 120 Manual Updated -

Carefully cut the end of the welding wire away from the spool. Hold the wire securely so it does not unravel.

Slide the correct size contact tip over the wire, screw it back in, and replace the gas nozzle. 4. Gas Connection (MIG Mode Only)

Check the thermal overload indicator. If illuminated, leave the machine turned on so the internal fan can cool down the transformer. It will auto-reset in 10 to 15 minutes. Safety Precautions

If using shielding gas, handle cylinders with care and avoid gas leaks. cem dual mig 120 manual

Fire-resistant welding jacket or heavy denim, leather welding gloves, and safety boots.

This article provides a comprehensive overview based on standard and best practices for setting up and operating this welder. 1. Safety Precautions Before operating the CEM Dual MIG 120

Fan-cooled with automatic thermal overload protection Carefully cut the end of the welding wire

A potentiometer typically graduated from 1 to 10. This controls the DC motor feeding the wire into the torch. It must be balanced in tandem with your chosen voltage setting.

Built-in 12V/24V DC motorized feed mechanism

A potentiometer graduated from 1 to 10 to control the DC motor driving the wire feed rollers. It will auto-reset in 10 to 15 minutes

Too little tension on roller; worn contact tip; kinked liner.

The Dual MIG 120 is designed primarily for light to medium-duty tasks. 230V (Standard UK/European plug). Amperage Range: Typically adjustable from 30A to 120A.